| ||||||||||||||||||||||
View Printer-Friendly PDF Page|
|
ANVER's Vacuum Reservoir can be used inline or as a
single-ported
auxiliary tank for faster attach. When used inline on non- to semi-porous loads,
it adds
safety in case of a power failure by increasing the vacuum in a system allowing
more time to safely lower the load. As an auxiliary tank it greatly increases
the speed of attachment if opened after a suction cup has seated on a load and the
attach mode has been activated. This is achieved using special valve
circuits. ANVER's series of large vacuum generators use
this system and come with built in reservoirs. ANVER's Vacuum Reservoir is made from sturdy 14 GA steel tubing and 11 GA end caps, welded to ANSI/AWS D14.1 specifications with a volume of 100 cubic inches (1639 cc). The 3/8-NPT ports on both ends provide easy integration into a vacuum system. The 3/8" x 1/2" mounting bracket, longitudinally welded to the tank side, provides a means to rigid mount the tank within a system configuration.
This tank may
also be used as a low pressure compression tank. Comes finished in a durable
safety-yellow powder coated surface.
Volume: 100 cubic inches (1639 cc) |
Specifications:
|
|
Product
Photo (Click to Enlarge) |
ANVER Item No. |
Volume |
Height in. (mm) |
Diameter in. (mm) |
Weight lb (kg) |
3/8" Fittings for Clamps and Hose |
|
|
cubic in. (cc) |
gal. (L) |
|||||||
|
|
 |
28400138 | 100 (1639) |
0.45 (1.7) |
9.24 (235) |
4.00 (102) |
4.15 (1.88) |
 |
| ||||||||